SIMPLE TOOLS YOU CAN MAKE

Dizzy Tool	For reaching that hard to get at bolt under the distributor
Bubble-O-Meter	Procedure for getting your pistons TDC every time with a home made tool
Bubble-O-Meter Vs.2 (Pic A) Bubble-O-Meter Vs.2 (Pic B)	A) Same principle as above but using a syringe and core removed plug still keeping ceramics. Can use without syringe as above B) Pic of it fitted to barrel.
Spring Remover	For rear shocks - pic ad excerpt from Rev's '82
Gearbox Hub Tools - Hub/peg nut remover - Sprag Tool	- tools for removing the splined hub from the gearbox - tool for stopping the hub/shaft from rotating, use with above tool
Flywheel Bolt Tool	- A simple device for stopping the flywheel from rotating.

DIZZY TOOL	TEST LIGHT
(A) Long spanner end (B) Short spanner end 13mm ring spanner (cut in half) 8mm-10mm x 400mm rod overall length Weld the spanner end to rod and bend the handle (150mm) in a vice. You can fit a rubber tube over the rod to protect the paintwork on your tank if you chose to tune with your tank on (back lifted up on a wood block).	1 x 12v lamp and base or buzzer 2 x 300mm wire (multistrand - speaker wires will do) 2 x alligator clips

GEARBOX HUB/NUT REMOVER
	NOTE: 95mm is approximate bent dimensions. With the aid of a block of 4x2 timber use this tool to lock the hub from turning. Pic from Haynes Manual "Moto Guzzi 750, 850 & 1000 V-Twins" p.56 pic 3.2c
SPINNING FLYWHEEL?
	HOW TO USE: To help the removal of the bolts on the ring gear to flywheel this simple tool comes in real handy. Position one end to a stud on the crankcase that locates the gearbox. Fit a bolt of similar diameter to the inside holes next to the ring gear bolts. This will lock the flywheel. Undo one ring gear bolt and replace the tool to this position for a more secure lock.